The main points of the Carrier 06E piston kit assembly are as follows:

1. Press-fit connecting rod copper sleeve. When installing the Carrier 06E piston kit, it is best to use a press, or a vise to do it, do not beat it with a hammer; the oil hole or oil groove on the copper sleeve should be aligned with the oil hole on the connecting rod to ensure its lubrication
2. Assemble the piston and connecting rod. When assembling the Carrier 06E piston kit, attention should be paid to their relative position and orientation.
3. Cleverly install the piston pin. The piston pin and the pin hole are an interference fit. When installing, first place the piston in water or oil and evenly heat it to 90°C~100°C. After taking it out, put the tie rod in the proper position between the piston pin seat holes, and then install the oil-coated piston pin in the predetermined direction. into the piston pin hole and the connecting rod copper sleeve.
4. Installation of piston rings. When installing the piston rings, pay attention to the position and order of each ring of the Carrier 06E piston kit.
5. Load the Carrier 06E piston kit.